Peter Banks Garage door openers are a convenience that many homeowners enjoy, as they provide a secure way to access their garage space without getting out of the car. If you recently purchased a 2019 Subaru with a built-in garage door opener, you may be wondering how to set it up and use it to its fullest potential. Fortunately, programming your Subaru garage door opener is a straightforward process that can be done in just a few simple steps. In this article, we’ll walk you through the process to ensure that you can enjoy the benefits of a well-programmed garage door opener with ease.
Understanding Your Garage Door Opener
Before delving into the programming process, it’s important to understand the basics of how your garage door opener works. When the opener is activated, it sends a signal to the receiver in your garage door motor, which then opens or closes the door. To program your Subaru garage door opener, you’ll need to sync it with the receiver by setting the correct codes.
Tools and Supplies You’ll Need
To program your garage door opener, you’ll need the following tools and supplies:
- Your 2019 Subaru with a built-in garage door opener
- The instruction manual for your garage door opener
- Your garage door remote
- A ladder (if necessary)
Programming Your Garage Door Opener
Now that you have everything you need, it’s time to start programming your garage door opener. Follow these simple steps:
-
Begin by parking your Subaru in front of your garage door, within range of the garage door opener.
-
Locate the "home link" button on the overhead console in your Subaru. It should be a black plastic button with three LEDs.
-
Press and hold the "home link" button until the LEDs start flashing. This will erase any previously programmed codes and prepare the button for programming a new code.
-
Next, take your garage door remote and hold it next to the "home link" button, pressing both at the same time. Hold them there until the LEDs on the "home link" button begin flashing rapidly. This should take about 30 seconds.
-
Release both buttons and then quickly press and hold the "home link" button again, this time for two seconds. The LEDs should flash slowly and then turn solid, indicating that the programming is complete.
-
Test the garage door opener by pressing the "home link" button. If everything was programmed correctly, the garage door should open or close as desired.
Troubleshooting Common Problems
If your garage door opener isn’t working as expected, there are a few common problems that you may be experiencing. Here are some solutions:
-
The "home link" button doesn’t seem to be working: Check the instruction manual for your garage door opener to ensure that you’re following the correct programming steps. It’s also possible that the battery in your garage door remote needs to be replaced.
-
The garage door opener isn’t responding: Try standing closer to the garage door opener and pressing the button again. If that doesn’t work, check to make sure that the garage door motor is functioning properly and that the receiver hasn’t been unplugged or damaged.
-
The garage door opens or closes randomly: This could be a sign that your garage door opener has been programmed with incorrect codes or that it’s receiving interference from another device. Try reprogramming the opener or moving nearby electronics away from the receiver.
Conclusion
Programming your 2019 Subaru garage door opener is a simple process that can be done in just a few steps. Whether you’re a first-time homeowner or a seasoned DIY enthusiast, it’s an easy way to ensure that you can access your garage space easily and securely. By following the steps outlined in this guide, you’ll be able to program your garage door opener with ease and enjoy all of the benefits that it has to offer.
