If you own a 2010 Subaru Outback, you might be wondering what type of battery your key fob uses. The key fob is an essential component of your vehicle, as it allows you to lock and unlock the doors remotely, and sometimes even start the engine. In this article, we will discuss the battery type, how to replace it, and some other useful information that you might find helpful.
- The 2010 Subaru Outback key fob uses a CR1620 3-volt lithium battery.
- Replacing the key fob battery is a simple process that can be done in a matter of minutes.
- If your key fob is not working, try replacing the battery before calling a professional.
- Always dispose of used batteries properly to protect the environment.
What Battery Does a 2010 Subaru Outback Key Fob Use?
The 2010 Subaru Outback key fob uses a CR1620 3-volt lithium battery. This type of battery is commonly used in many key fobs and other small electronic devices. It is a long-lasting battery that is designed to provide reliable power for several years.
How to Replace the Key Fob Battery
Replacing the key fob battery is a simple process that can be done in a matter of minutes. Here are the steps:
- Locate the small notch on the side of the key fob.
- Use a small flathead screwdriver or a coin to gently pry open the fob.
- Remove the old battery and insert the new one, making sure it is properly seated.
- Close the key fob by pressing the two halves together until you hear a click.
That’s it! Your key fob should now be working properly.
What to Do If Your Key Fob Is Not Working
If your key fob is not working, the first thing you should try is replacing the battery. A dead battery is usually the most common reason why a key fob stops working. If that doesn’t solve the problem, there could be a few other reasons why your key fob is not working. Here are a few troubleshooting tips:
- Make sure your key fob is within range of your vehicle.
- Check the battery contacts for any signs of corrosion or damage.
- Try reprogramming the key fob by following the instructions in your owner’s manual.
- If none of these steps work, you may need to have your key fob serviced or replaced by a professional.
In conclusion, the 2010 Subaru Outback key fob uses a CR1620 3-volt lithium battery. Replacing the battery is a simple process that can be done at home in just a few minutes. If your key fob is not working, try replacing the battery before calling a professional. Always remember to dispose of used batteries properly to protect the environment.