Are you tired of driving around with a damaged wheel cover trim? Do you want to fix it yourself but don’t know how? If you own a Subaru Outback, then you’re in luck. In this article, we will provide you with a step-by-step guide on how to fix the wheel cover trim on your Subaru Outback in just six easy steps.
Introduction to the Problem
Subaru Outback owners often face the problem of damaged wheel cover trim due to uneven roads or parking mishaps. This may lead to an unsightly appearance of the vehicle, and also impact its performance. Fixing this problem at a professional auto shop can be expensive. However, this is a quick and easy repair that can be done at home to save time and money.
Tools Needed to Fix the Issue
Before you start the repair process, you will need to gather a few tools. The list of tools needed for this repair includes:
- Thin plastic pry tool
- Adhesive glue
Step-by-Step Guide on How to Fix the Wheel Cover Trim on a Subaru Outback
Now that you have the necessary tools, follow the steps below to fix the wheel cover trim on your Subaru Outback:
Step 1: Remove the Damaged Wheel Cover Trim
Use a screwdriver and pliers to remove the damaged trim from the wheel cover. Be gentle and careful not to damage the wheel cover in the process.
Step 2: Clean the Surface
Clean the surface area where the trim was attached on the wheel cover. Use a thin plastic pry tool to remove any leftover adhesive.
Step 3: Apply Adhesive Glue
Apply adhesive glue on the back of the replacement trim. Make sure to spread the glue evenly.
Step 4: Attach the Replacement Trim
Attach the replacement trim on the wheel cover. Ensure that it is aligned properly and lightly press it on the surface.
Step 5: Allow the Glue to Dry
Allow the adhesive glue to dry for at least 24 hours before using the vehicle to ensure a secure bond.
Step 6: Clean the Wheel Cover
After the glue has dried, clean the entire wheel cover to remove any remaining glue residue. You may use a solution of soap and water to clean the area.
Tips on Avoiding Common Mistakes While Fixing the Trim
Here are some useful tips on avoiding common mistakes while fixing the trim of your Subaru Outback’s wheel cover:
- Be gentle while removing the damaged trim to avoid any damage to the wheel cover.
- Use a thin plastic pry tool to remove any adhesive residue to prevent any scratches on the wheel cover.
- Make sure that the replacement trim is aligned properly before finally pressing it in place.
How to Maintain the Trim to Avoid Future Damages
To avoid future damages to the trim, you can follow these tips:
- Avoid parking your vehicle in tight spaces to avoid damage caused by other vehicles.
- Clean your wheels and wheel covers periodically to prevent dirt buildup that can damage the trim.
- Check your Subaru Outback’s wheel covers regularly to spot any damage early and prevent further damage.
Q: Is it necessary to replace the entire wheel cover if only the trim is damaged?
A: No, you can replace only the damaged trim instead of the whole wheel cover.
Q: Can I use any type of adhesive glue to fix the trim?
A: No, it is recommended to use an adhesive glue recommended by the manufacturer.
Q: Can I drive the vehicle immediately after fixing the trim?
A: No, it is recommended to wait for at least 24 hours to ensure a secure bond between the replacement trim and the wheel cover.
In conclusion, fixing the wheel cover trim on your Subaru Outback is a simple process that can be done at home. By following the easy guide provided in this article, you’ll be able to do it yourself without the need to visit a professional auto shop. Don’t let a damaged wheel cover trim ruin the appearance of your vehicle, fix it yourself!