Davis Bellew If you’re planning to install new seats in your 2010 Subaru Legacy, you might want to remove the middle seat belt to make more room for your passengers. Removing the middle seat belt may seem like a daunting task, but with the right tools and some simple steps, you can easily get it done.
Key Takeaways
- Removing the middle seat belt in a 2010 Subaru Legacy is a straightforward process.
- You will need a Torx driver, a Philips head screwdriver, and a flat head screwdriver to remove the seat belt.
- Make sure you disconnect the negative battery cable before starting to ensure your safety.
- Once you remove the middle seat belt, ensure that you replace it with a new one.
- You can reinstall the middle seat belt by following these steps in reverse.
With these key takeaways in mind, let’s dive into the steps needed to remove the middle seat belt in your 2010 Subaru Legacy.
Step-by-Step Guide to Remove the Middle Seat Belt
Step 1: Disconnect the Negative Battery Cable
Before starting the process, make sure that you disconnect the negative battery cable. This is to ensure your safety and to avoid any electrical issues.
Step 2: Remove the Rear Seat Cushion
The rear seat cushion needs to come off to remove the middle seat belt. Here’s how:
- Locate the two release tabs at the front of the cushion and push them down.
- Lift the cushion up and then remove it from the car.
Step 3: Remove the Middle Seat Belt Cover
The middle seat belt cover needs to be removed to get access to the seat belt.
- Use a flat head screwdriver to remove the plastic cover at the base of the middle seat belt.
- Use a Torx driver to remove the two bolts that are holding the seat belt cover in place.
- Lift the seat belt cover up and away from the seat belt.
Step 4: Remove the Seat Belt
Now that you have access to the seat belt, it’s time to remove it.
- Use a Philips head screwdriver to remove the bolt that is holding the seat belt to the car.
- Pull the seat belt out from the car and then remove the plastic clip that’s holding it in place.
Congratulations! You have successfully removed the middle seat belt from your 2010 Subaru Legacy.
FAQs
How long does it take to remove the middle seat belt?
The whole process should take around 30 minutes to an hour.
Can I drive the car without the middle seat belt?
We highly recommend that you do not drive the car without the middle seat belt. The seat belt is there to keep you and your passengers safe.
Do I need to replace the middle seat belt after removing it?
Yes, you should replace the middle seat belt after removing it. This is to ensure that the car is safe to drive.
Can I reuse the middle seat belt after removing it?
We do not recommend reusing the middle seat belt once it has been removed. It’s always best to replace it with a new one.
Conclusion
Removing the middle seat belt from your 2010 Subaru Legacy is a straightforward process that can be done with the right tools and some simple steps. Always ensure that you replace the seat belt with a new one after removing it. With these steps, you can easily make more room for your passengers or get started on a new project.
