Alton Brobst Are you experiencing issues with your Subaru Legacy’s axle shaft? Maybe you need to replace it, or perhaps you need to remove it for other repairs. Whatever the reason may be, removing the axle shaft from your 2007 Subaru Legacy can be a daunting task. But don’t worry, we’ve got you covered with this step-by-step guide on how to remove the axle shaft from your 2007 Subaru Legacy.
Key Takeaways
- Removing the axle shaft from your 2007 Subaru Legacy doesn’t have to be difficult.
- You’ll need to jack up your car and remove the wheel to access the axle shaft.
- It’s important to have the right tools on hand before you begin.
- Always follow safety precautions when working on your car.
Tools You’ll Need
Before you begin, it’s important to have the right tools on hand. Here’s what you’ll need:
- Jack and jack stands
- Lug wrench
- Socket set
- Pry bar
- Hammer
- Axle puller (optional)
Step-by-Step Guide
Now that you have all of the necessary tools, it’s time to get started. Follow these steps to remove the axle shaft from your 2007 Subaru Legacy:
Step 1: Safely Jack Up Your Car
Before you begin, make sure your car is parked on a level surface and the emergency brake is engaged. Use the lug wrench to loosen the lug nuts on the wheel where you’ll be removing the axle shaft.
Next, place the jack under the jacking point on the frame of the car and lift it until the wheel is off the ground. Then, place a jack stand under the car’s frame near the jacking point and lower the car onto the stand. Repeat this process on the other side of the car.
Step 2: Remove the Wheel
Now that the car is safely jacked up, it’s time to remove the wheel. Use the lug wrench to remove the lug nuts and take the wheel off.
Step 3: Remove the Axle Nut
Locate the axle nut on the center of the hub assembly. Use the appropriate socket and breaker bar to remove the axle nut. You may need to use a pry bar to hold the hub assembly in place while you loosen the nut.
Step 4: Remove the Hub Assembly
Now that the axle nut is removed, you can remove the hub assembly. You may need to use a hammer to tap the assembly loose. Be careful not to damage any of the components while doing this.
Step 5: Remove the Axle Shaft
With the hub assembly out of the way, you can now remove the axle shaft. Grip the axle shaft near the inner CV joint and pull it out of the transmission. If the axle shaft is stuck, you may need to use an axle puller to remove it.
Step 6: Inspect the Axle Shaft
Before installing a replacement axle shaft, it’s important to inspect the old one for any signs of damage. Look for cracks, bends, or other signs of wear and tear.
FAQs
Q: Can I remove the axle shaft without jacking up the car?
A: No, you’ll need to jack up the car and remove the wheel to access the axle shaft.
Q: Do I need to replace the axle shaft after removing it?
A: Not necessarily. You can inspect the old axle shaft for signs of damage and replace it if necessary.
Q: Do I need to replace the axle nut after removing it?
A: It’s recommended to replace the axle nut, as it can become damaged during removal.
Conclusion
Removing the axle shaft from your 2007 Subaru Legacy may seem daunting, but with the right tools and a bit of patience, it’s a task that can be completed in a few steps. Remember to always follow safety precautions and inspect the old axle shaft for any signs of damage before installing a replacement. With this guide, you’ll be able to remove the axle shaft from your Subaru Legacy like a pro.
